• Monday - Friday 10am-6pm
    Saturday 10am-5pm
  • Strings
    Picks
  • Unable to display Facebook posts.
    Show error

    Error: (#803) Cannot query users by their username (orcoastmusic)
    Type: OAuthException
    Code: 803
    Please refer to our Error Message Reference.
  • quantumblender
Sale!

K & K Sound Quantum Blender

0 reviews
0 out of 5

$504.00 $352.00

Out of stock

The Quantum Blender is a two-channel preamp/mixer but this unit goes one step further. Two fully independent channels feature special tailored powerful 3-band EQ, phase reverse switches, gain and volume controls. Mixed output options in both active-balanced and 1/4″ line-level format, individual outputs, stereo and mono inputs, and effect loop. Channel one is switchable from mic to pickup impedance. All this, plus K&K’s ultra low noise circuitry.

The Quantum Blender allows for mixing a piezo transducer with a microphone, magnetic pickup or another piezo pickup. It can be used with any “2 wire” powered lavalier type condenser mic or with a piezo or magnetic pickup. With an appropriate microphone impedance matching transformer a dynamic mic can be used as well. Channel 2 is designed with K&K’s Trinity System or Pure Pickup in mind, but it works well with all types of piezo transducers.

Gain: The 2 gain controls allow for adjusting the input sensitivity of each channel. Here you can set the sensitivity of each channel to fit different pickups, microphones or transducers.

Inputs: Stereo 1/4″ line input · 2 individual mono 1/4″ line inputs

Outputs: Balanced XLR Mix out (carries both channels) · Line level 1/4″ Mix out (carries both channels) · Individual 1/4″ line outputs of channel 1 and 2

Effect Loop: The effect loop allows for connecting to an effect unit (like reverb) via a special 1/4″ stereo cable with a stereo plug on one side and 2 mono 1/4 plugs on the other.


Technical Data

EQ Frequencies Channel 1:
– Bass : 100 Hz (high pass filter) +/- 18 dB
– Midrange : 1500 Hz (band pass filter) +/- 12dB
– Treble : 8000 Hz (low pass filter) +/- 18 dB

EQ Frequencies Channel 2:
– Bass : 100 Hz (high pass filter) +/- 15 dB
– Midrange : 1500 Hz (band pass filter) +/- 18dB
– Treble : 10 000 Hz (low pass filter) +/- 15 dB

Frequency Response:
– Channel 1: 10Hz to 35KHz.
– Channel 2: 10Hz to 35KHz.

Distortion: Less than 0.005% @ 1KHz
Signal to noise ratio: – 85dB – A weighted, referred to nominal – 20dBV input

Input Impedance:
– Channel 1 pickup: 1 Meg Ohms.
– Channel 1 mic: 3 Kilo Ohms.
– Channel 2 transducer: 1 Meg Ohms.

Mic Power: 9volt DC max
Power source: 12 volt DC – 700 milli amp minimum- automatic polarizing